Modeling and Control of a 7-phase Claw-pole Starter-alternator for a Micro-hybrid Automotive Applications

Archive ouverte : Communication dans un congrès

Bruyère, Antoine | Semail, Eric | Bouscayrol, Alain | Locment, Fabrice | Mipo, Jean-Claude

Edité par HAL CCSD ; IEEE

International audience. This paper deals with the modeling and the control of a new high power 12V Integrated Starter Alternator (ISA). This system is used to bring micro-hybrid functions to standard Internal Combustion Engine (ICE) vehicles. The drive is composed of a seven-phase synchronous claw-pole machine with separate excitation, supplied with a seven-leg Voltage Source Inverter (VSI) designed for low voltage and high current. The system is modeled in a generalized Concordia frame and a graphical description is used to highlight energetic properties of such a complex system. A control scheme is then deduced from this graphical description. Two controls are achieved in generator mode and compared: one is using the VSI in a square-wave mode, the other in a Pulse Width Modulation (PWM) mode. Experimental results are provided.

Consulter en ligne

Suggestions

Du même auteur

Identification of a 7-phase claw-pole starter-alternator for a micro-hybrid...

Archive ouverte: Communication dans un congrès

Bruyère, Antoine | 2008-09-06

International audience. This paper deals with the identification of a new high power starter-alternator system, using both: a Finite Element Method (FEM) modeling and an experimental vector control. The drive is com...

Control Strategies for Open-End Winding Drives Operating in the Flux-Weaken...

Archive ouverte: Article de revue

Sandulescu, Paul | 2013-09-23

International audience. This paper presents and compares control strategies for three-phase open-end winding drives operating in the flux-weakening region. A six-leg inverter with a single dc-link is associated with...

Identification of sensitive R-L parameters of a Multi-phase drive by a vect...

Archive ouverte: Communication dans un congrès

Bruyère, Antoine | 2008-06

International audience. This paper focuses on an experimental method to determine the electric parameters of a seven-phase low-voltage multiphase drive. The drive is a belt driven starter-alternator for powerful car...

Du même sujet

Identification of a 7-phase claw-pole starter-alternator for a micro-hybrid...

Archive ouverte: Communication dans un congrès

Bruyère, Antoine | 2008-09-06

International audience. This paper deals with the identification of a new high power starter-alternator system, using both: a Finite Element Method (FEM) modeling and an experimental vector control. The drive is com...

Identification of sensitive R-L parameters of a Multi-phase drive by a vect...

Archive ouverte: Communication dans un congrès

Bruyère, Antoine | 2008-06

International audience. This paper focuses on an experimental method to determine the electric parameters of a seven-phase low-voltage multiphase drive. The drive is a belt driven starter-alternator for powerful car...

Right Harmonic Spectrum for the back-electromotive force of a n-phase synch...

Archive ouverte: Communication dans un congrès

Semail, Eric | 2004-10

This paper deals with a vector control of n-phase permanent magnet synchronous machine. To use control algorithms already developed for sine-wave 3-phase machines,the spectrum of back electromotive force (EMF) must contain only od...

Electric Vehicles Driven by 5-phase Open-End Winding Machines Fed by Batter...

Archive ouverte: Communication dans un congrès

Vu, Duc Tan | 2019-10-15

International audience. This paper presents the modeling and control of an Electric Vehicle (EV) driven by a 5-phase Permanent Magnet Synchronous Machine (PMSM). The machine in an open-end winding configuration is s...

Two-Slot Coil Pitch For Five-Phase Integrated Permanent Magnet Synchronous ...

Archive ouverte: Communication dans un congrès

Cousseau, R. | 2020-08

International audience. This paper presents a simple method to size a concentrated winding permament magnet synchronous machine when a high number of slots is needed. A classical concentrated winding machine leads t...

Chargement des enrichissements...