Fault Tolerant Control of a Seven-phase Drive by Degrees of Freedom Adaptation

Archive ouverte : Communication dans un congrès

Kestelyn, Xavier | Crevits, Yvan | Semail, Eric

Edité par HAL CCSD ; IEEE

La version éditeur est disponible à l'adresse suivante : http://ieeexplore.ieee.org/stamp/stamp.jsp?tp=&arnumber=5472476&isnumber=5472440. International audience. This paper proposes a simple way to control multi-phase drives in open-phase conditions. Contrary to existing methods, current references are not recomputed and the control scheme is kept the same to run in open-circuited phase condition. In order to work in fault-conditions, the number of degrees of freedom of the control scheme is adapted to the number of degrees of freedom of the drive. Since a particular attention has to be dedicated to the structure and controller tuning, harmonic content of induced perturbations in fault mode is exhibited. Simulation and experimental results are presented to show the effectiveness and the limitations of the proposed method.

Consulter en ligne

Suggestions

Du même auteur

Generation of On-line Optimal Current References for Multi-phase Permanent ...

Archive ouverte: Communication dans un congrès

Kestelyn, Xavier | 2009-05

Acces éditeur : URL: http://ieeexplore.ieee.org/stamp/stamp.jsp?tp=&arnumber=5075280&isnumber=5075166. This paper deals with the generation of optimal current references for Multi-phase Permanent Magnet Machines wit...

Modélisation causale pour la commande auto adaptée de machines alternatives...

Archive ouverte: Article de revue

Crevits, Yvan | 2010-06

Version éditeur disponible à cette adresse : http://ejee.revuesonline.com/article.jsp?articleId=14944. International audience. After a short historic of the multiphase machines and the state of the art of their open...

Auto-adaptive fault tolerant control of a seven-phase drive

Archive ouverte: Communication dans un congrès

Kestelyn, Xavier | 2010-07-04

International audience. This paper proposes an auto-adaptive current control that makes possible to reduce torque ripples of multi-phase machines in open-circuited phase conditions. Contrary to existing methods, cur...

Du même sujet

Comparison of five-phase, six-phase and seven-phase fault tolerant electric...

Archive ouverte: Communication dans un congrès

Ribiere, Antonin | 2022-06

International audience. Automotive industry is evolving towards more fault-tolerant actuators to fulfill future autonomous vehicles requirements. Critical applications such as steering or braking have to resist to f...

Fault tolerant control with delays systems: Application to a PEMFC system

Archive ouverte: Communication dans un congrès

Bougatef, Zina | 2020-11-24

International audience. he problem of active Fault Tolerant Control (FTC) for a Polymer Electrolyte Membrane Fuel Cell (PEMFC) systems with time delays subject to an actuator fault, is investigated in this paper. Th...

Torque Optimization of a Seven-Phase Bi-harmonic PMSM in Healthy and Degrad...

Archive ouverte: Communication dans un congrès

Zhang, Hao | 2019-08-11

International audience. Compared to sinusoidal machines, a bi-harmonic machine (with only two harmonics of similar value in the electromotive force spectrum) can develop torque of comparable values under three kinds...

Active fault tolerant control of wind turbine systems based on DFIG with ac...

Archive ouverte: Article de revue

Li, Shanzhi | 2018

International audience. This paper presents an active fault tolerant control (FTC) for doubly fed induction generator (DFIG) with actuator fault and disturbance using Takagi-Sugeno(TS) fuzzy model. The control struc...

Comparison and Analysis of Post-Fault Operation Modes in a Five-Phase PMSM ...

Archive ouverte: Communication dans un congrès

Zahr, Hussein | 2018-04-10

International audience. This paper presents a comparative evaluation of fault tolerant control strategies for a five-phase Permanent Magnet Synchronous Machine (PMSM) under an opened-phasefault mode. Two main classi...

An Overview of Methods using Reduced-Ordered Transformation Matrices for Fa...

Archive ouverte: Communication dans un congrès

Vu, Duc Tan | 2019-02-13

International audience. This paper studies control strategies using modified transformation matrices when five-phase machines operate in oneopen-phase faults. The basic idea of these methods is to maintain the rotat...

Chargement des enrichissements...