Comparison of Two Distincts Approaches for Wind Turbines Control Design

Archive ouverte : Communication dans un congrès

Camblong, Haritza | Guillaud, X. | Rogez, V.

Edité par HAL CCSD

International audience. This paper presents the comparison of two approaches for Wind Turbines (WT) control design. The classical approach analyses the system for choosing the controlled variables before designing a linear controller. The second approach consists on inversing a Causal Ordering Graph (COG) representing the system in order to design a non linear controller. After giving the main control objectives and the modelling of the considered WT, the design of the controllers in Partial (PL) and Full Load (FL) is described. Simulations show that the two approaches give similar results in PL and that the COG approach leads to a better WT behaviour in FL.

Consulter en ligne

Suggestions

Du même auteur

Distribution System Constraints For Wind Turbine Integration in Island Grid...

Archive ouverte: Communication dans un congrès

Marin, David | 2008-03-31

International audience

Comparison of Three Wind Turbine Controller Synthesis Methodologies

Archive ouverte: Communication dans un congrès

Camblong, Haritza | 2006

International audience

Wind turbine controller comparison on an island grid in terms of frequency ...

Archive ouverte: Article de revue

Camblong, Haritza | 2013-08-28

ISSN: 0960-1481. International audience. The aim of this paper is to present a linear quadratic Gaussian (LQG) controller designed with two main objectives: to allow the contribution of wind turbines (WTs) to the pr...

Du même sujet

Inversion-based control of electromechanical systems using causal graphical...

Archive ouverte: Communication dans un congrès

Barre, Pierre-Jean | 2006-11

Causal Ordering Graph and Energetic Macroscopic Representation are graphical descriptions to model electromechanical systems using integral causality. Inversion ruleshave been defined in order to deduce control structure step-byst...

Characterization and causal modelling of a magnetorheological fluid brake f...

Archive ouverte: Thèse

Demersseman, Richard | 2009-09-14

Magnetorheological fluids are suspensions of micrometric magnetic particles in nonmagnetic fluids. When such a fluid is exposed to a magnetic field, the particles agregate into "chains" which increase the flow resistance highly. I...

Analysis of parallel multi-actuated systems using causal ordering methods. ...

Archive ouverte: Thèse

Gomand, Julien | 2008-12-04

ANALYSIS OF PARALLEL MULTI-ACTUATED SYSTEMS USING CAUSAL ORDERING METHODS - APPLICATION TO MOTION CONTROL OF A DUAL-DRIVE HIGH-SPEED POSITIONING GANTRY STAGE High-dynamic positioning systems are required to increase production rat...

Optimized control of a linear synchronous motor for a high speed positionni...

Archive ouverte: Thèse

Remy, Ghislain | 2007-12-17

Linear Motors have become leading component in the field of the high-speed machine tools. Nowadays, the Permanent Magnet Linear Synchronous Motor (PMLSM) is the main component permitting to obtain higher performances than its rota...

Dynamical Coupling of a Battery Electro-Thermal Model and the Traction Mode...

Archive ouverte: Article de revue

German, Ronan | 2019-11-25

International audience. The driving range of electric vehicles is a complex issue. In simulation, this range is determined by coupling a battery model and a traction model of the vehicle. But most of the battery mod...

Residual correlation and ensemble modelling to improve crop and grassland m...

Archive ouverte: Article de revue

Sándor, Renáta | 2023-01-13

International audience. Model calibration Residual plot analysis rotations including fallow periods. We do that by exploring the correlation of model residuals. We restricted the distinction between partial and full...

Chargement des enrichissements...